How to keep the wheat harvester when it is not in use? The price of small tractor is introduced by Huaxing agricultural machinery

1. Open the cover and shield on the wheat combine to clean the inside and outside dust, straw, Miscanthus and weeds on the machine.

2. Drive into the garage and let out the oil and cooling water. And dehydration of the newly added lubricating oil (heated to 110-150 degrees, until the foam disappeared). Then crank the crankshaft several turns to fill the entire lubrication system. Then wrap up the air filter, exhaust pipe, water tank cover and fuel tank cover with plastic cloth.

3. Put the header of the wheat combine on the prepared skid, jack up the axle, support the cushion, and let the tire leave the ground. In order to reduce the pressure of inner tube to outer tube, the tire pressure should be set to 0.05 MPa.

4. Take off all the belts (V-belts). Those that can still be used after technical appraisal should be wiped clean, coated with talcum powder, attached with labels, and kept in a cool and dry place. If you want to put it on the wall, try not to let the belt roll.

5. Take off the wooden bearing bush on the drive chain and the draft chaser, clean the oil sludge, dig out the oil, soak it in the engine oil for one day and night, or soak it in anhydrous engine oil for 20-30 minutes, then take it out. After the oil on it drips completely, wrap it with kraft paper or plastic cloth, and store it in a ventilated and dry room.

6. According to the lubrication chart, use the oil gun to add grease to each lubrication point to lubricate all parts of the wheat combine.

7. Remove the battery, keep it separately, and charge it once a month during the storage period. After charging, clean the battery * and paint it with Ventolin.

8. Replace worn and damaged parts. If there is no replacement part for the time being, it shall be marked and replaced before the next year's operation.

9. Oil and antirust the paint falling parts.