How to keep the wheat harvester when it is not in use?

1. Open the cover and shield on the wheat combine to clean the inside and outside dust, straw, Miscanthus and weeds on the machine.

2. Drive into the garage and let out the oil and cooling water. And dehydration of the newly added lubricating oil (heated to 110-150 degrees, until the foam disappeared). Then crank the crankshaft several turns to fill the entire lubrication system. Then wrap up the air filter, exhaust pipe, water tank cover and fuel tank cover with plastic cloth.

3. Put the header of the wheat combine on the prepared skid, jack up the axle, support the cushion, and let the tire leave the ground. In order to reduce the pressure of inner tube to outer tube, the tire pressure should be set to 0.05 MPa.

4. Take off all the belts (V-belts). Those that can still be used after technical appraisal should be wiped clean, coated with talcum powder, attached with labels, and kept in a cool and dry place. If you want to put it on the wall, try not to let the belt roll.

5. Remove the wooden bearing shells on the drive chain and the draft machine, clean the oil mud, dig out the oil, soak it in the oil for one day and night or soak it in anhydrous oil for 20-30 minutes, and then remove the oil. The oil to be stuck on it is cleaned, wrapped in kraft paper or plastic cloth respectively, and stored in a ventilated and dry room.

6. According to the lubrication chart, grease the lubricating points with oil gun to lubricate all parts of the wheat combine.

7. Remove the battery, keep it separately, and charge it once a month during storage. Clean the electricity after charging, and apply all the soil forest.

8. Replace the parts which are seriously worn and damaged. If there is no replacement for a time, mark it and replace it before the next year's operation.

9. For the parts that are removed, the oil shall be coated and rust proof treatment shall be done.